Ready to learn to make a gorgeous and sturdy farmhouse table from scratch? Use the plans below to build your own.
The Triangles: I’d recommend doing the triangles however you think looks best. If you want to know what size the triangles on my table feet are, they measure 9 3/4″ on the diagonal side (the longest side) x 3 1/2″ at the bottom x 9″ tall. I used 4×6 lumber to make these.
A quick note on the end caps. I’m not sure I’d honestly recommend them. The problem is that the wood will shrink and expand more in one direction than the other, which means that while the table top may move a bit in one direction, the end cap, by virtue of being perpendicular to the rest of the top, will move in the other direction. On my table this has resulted in a bit of a lip. Nothing huge, but not what I hoped for. I’d recommend leaving the wood out for several weeks first, or possibly omitting the end cap altogether. Another option is to create an end cap (for the lip) by cutting off 1.5″ from the table top and then attaching that to the bottom of the ends – to help match up the skirts. I attached the end caps with glue and brads at first, followed up with some pocket hole screws from the bottom side. If you’re just doing the skirt method, then I’d recommend screwing them in from the bottom using 2.5″ countersunk screws. The end cap dimensions (as shown in the plans) are 3’6″ W x 3″ H x 1.5″ D.
As for the side skirts, it’s just a 2×4 ripped in half and then glued, tacked and screwed onto the table top. I countersunk all of the screws and that one worked out pretty well. The side skirts are 7’9″ W x 1.5″ H x 1.5″ D.
Several people have asked about how I attached the base of the table to the tabletop, so I wanted to address that. I used 4 1/2″ lag bolts with washers and put them in six locations under the table – one on each corner of the two main legs, plus one in the center of the 2x4s that run the length of the base. To predrill, I started with a 7/8″ forstner bit, drilling just as deep as was necessary to hide the head of the bolt. From there, I used a 7/16″ bit to drill through about two inches in, then a 9/32″ bit to drill the rest of the 4 inches or so. Be careful not to drill too deep – you don’t want to drill right through the table top.
Drive the lag bolt in and let the washer stop you when it bottoms out. I think the six heavy duty bolts are enough but if you want to put more in, it couldn’t hurt.
Watch the video to see how it’s made! ^^